EasyManua.ls Logo

Inanny NC112 - Disposal; Technical Data

Inanny NC112
62 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem
Solution
What should I do if I have forgotten my
password
?
In the app tap “Forgot password” and enter your e-mail
address. A new password
will be sent to your e-mail
address.
I have not received an e-mail, even
though I have used the “Forgot
pass
word” function.
1. The e-mail may be in the spam folder of your e-mail
account. Check the spam folder for the e-mail.
2. The e-mail may not have arrived yet. Check your
e-mail account again after a few minutes.
If I try to add a new camera to my user
account, no available cameras
appear
.
Press thePAIR” button on the camera for 5 seconds
and
try again.
During the set-up process, no camera
appears in the last step. The set-up
process is interrupted.
Switch the camera of and back on again. Press the
PAIR” button until there is a beep. Wait for a minute until
the indicator lamp flashes. The camera is now r
eady for
the set-up process. Start the set-up process for the
camera again.
If I try to view the transmission image,
I received the message that I should
update my Firmware.
Conduct a Firmware update. We update the app from
time to time to constantly improve the camera function.
11. Disposal
For environmental reasons, do not dispose of the device in the household
waste at the end
of its useful life.
Dispose of the unit at a suitable local collection or recycling point. Dispose of
the
device in accordance with EC Directive - WEEE (Waste Electrical and
Electronic
Equipment). If you have any questions, please contact the local
authorities re
sponsible for waste disposal.
12. Technical Data
Frequency 2.4 - 2.483 GHz
Digital receiver
Infrared technology
Camera dimensions: 9.0 x 6.5 x 5.8 cm
Camera weight: 95g
Application
temperature:
0 - 50°C
Power adaptor: By Ten Pao International Ltd.
S005ANB0500100 (For UK)
S005ANV0500100 (For EU)
Input: 100 - 240 VAC, 50/60 Hz, 300mA
Output: 5VDC, 1000mA
Use only the power supply listed in the user instructions.
We hereby guarantee that this product complies with the European R&TTE Directive 1999/5/
EC. Please contact the specified service address to obtain further information, such as the
CE Declaration of Conformity.
10

Table of Contents