Inanny NM108 - What if There Are Problems

10. What if there are problems?
“Monitor” parent unit will not Check whether
• the mains part plug is correctly connected,
• the battery is correctly inserted,
•
the battery is full, needs charging or is damaged.
An acoustic signal sounds from
the “monitor” parent unit.
Check whether
• the maximum range has been exceeded,
• the main part plug for the camera is correctly
connected,
• the camera is switched on,
• the parent unit’s battery needs charging.
The parent unit is switched on,
•
To set your desired volume on the parent unit, press
but is not making any noise.
the right or left arrow buttos during operation.
The “monitor” parent unit
switches itself off.
• Recharge the parent unit’s battery,
• It could be that the parent unit is in energy-saving
mode. Check whether the power-saving mode has
been selected in the menu and deactivate it where
necessary.
The signal is weak, the
If no transmission is possible,
you have the option to retune
the device signals digitally =
pairing.
1. Switch on the camera and parent unit.
2. Delete the camera in the menu of the parent unit
and the set up the camera again as described in
the “Add camera” section.
11
“Monitor” parent unit will
not switch on.
Check whether
• the mains part plug is correctly connected,
• the battery is correctly inserted,
• the batter
y
is full
,
needs char
g
in
g
or is dama
g
ed.
An acoustic signal sounds
from the “monitor” parent
unit.
Check whether
• the maximum range has been exceeded,
• the mains part plug for the camera is correctly
connected,
• the camera is switched on,
• the parent unit’s battery needs charging.
The parent unit is switched on,
but is not makin
g
an
y
noise.
•
To set your desired volume on the parent unit, press the
right or left arrow buttons during operation.
The “monitor” parent unit
switches itself off.
• Recharge the parent unit’s battery,
• It could be that the parent unit is in energy-saving
mode. Check whether the power-saving mode has
been selected in the menu and deactivate it where
necessar
y
.
The signal is weak, the
connection keeps
breaking up or there is
interference.
• If another technical device such as a microwave is in
the area between the camera and the parent unit,
remove the technical device or switch it off.
• Check whether other factors, such as trees or
anything else are in the area between the camera
and the parent unit, and change the position of the
devices until the parent unit signals a connection.
• Check whether the camera and parent unit are
inside the maximum receiving range.
If no transmission is possible,
you have the option to
retune the device signals
digitally = pairing.
1. Switch on the camera and parent unit.
2. Delete the camera in the menu of the parent unit
and the set up the camera again as described in
the “Add camera” section.
English