4
LED Indicator
How to Use
1. Pairing
1) Set your Bluetooth enabled devices like Bluetooth headphones or
speakers to pairing mode.
2) Set the BR1005 to TX mode. Then press and hold the Multifunction
Button for 3 seconds to turn it on. Tap the Multifunction Button
twice to enter pairing mode with the LED indicator keeps rapidly
flashing blue. The BR1005 will automatically exit pairing mode if
there is no device to be connected within 2 minutes.
3) Place your Bluetooth audio receiving devices like earphones or
speakers closely to the BR1005. After approximately 30 seconds,
pairing will be completed. The BR1005 LED indicator will turn solid
blue.
4) Switch between AUX and SPDIF mode. Connect the BR1005 to
your audio output devices like TV through a 3.5mm audio cable or
optical digital cable.
Note:
a. BR1005 will enter pairing mode automatically when powered on for
the rst time.
b. BR1005 can only automatically re-pair to the 4 most recently
connected devices.
2. Pair with two devices at the same time
In TX mode, BR1005 is able to pair with two Bluetooth stereo
earphones / speakers at the same time. And both can play music at
the same time.
1) Follow the previous instructions in the “Pairing” section to pair
the BR1005 with your first device. Turn off your first device after
successfully pairing it with the BR1005.
2) Tap the Multifunction Button twice to pair and connect to your
second device. Turn o the BR1005 after successfully pairing it with
your second device.
LED Indicator (TX Mode) Status
Rapidly Flashing blue In pairing mode
Blue LED ashes twice every 3 seconds Automatically Pairing with Previously Paired Devices
Solid blue Successfully paired
To Next Page
Loading...