Inateck BR1006 - LED Indicator (TX Mode); How to Use: TX Mode Pairing

4
LED Indicator
LED Indicator (TX Mode) Status
Rapidly Flashing blue In pairing mode
Blue LED ashes twice every 3 seconds Automatically Pairing with Previously Paired
Devices
Blue LED ashes 4 times every 10 seconds Successfully paired with aptX HD
Blue LED ashes 3 times every 10 seconds Successfully paired with aptX low latency
Blue LED ashes twice every 10 seconds Successfully paired with aptX
Blue LED ashes once every 10 seconds Successfully paired with SBC
Solid green Pair with two devices at the same time
How to Use
1. Pairing
1) Set your Bluetooth enabled devices like Bluetooth headphones or
speakers to pairing mode.
2) Set the BR1006 to TX mode. Then press and hold the Multifunction
Button for 3 seconds to turn it on. Tap the Multifunction Button twice
to enter pairing mode with the LED indicator keeps rapidly ashing
blue. The BR1006 will automatically exit pairing mode if there is no
device to be connected within 2 minutes.
3) Place your Bluetooth audio receiving devices like earphones or
speakers closely to the BR1006. After approximately 30 seconds,
pairing will be completed. The BR1006 LED indicator will turn solid
blue.
4) Connect the BR1006 to your audio output devices like TV through a
3.5mm audio cable.