Need help?Do you have a question about the Inateck BR1008 and is the answer not in the manual?
General| Model | BR1008 |
|---|---|
| Audio Codec | SBC |
| Charging Port | Micro USB |
| Bluetooth Range | 10 meters |
| Supported Profiles | A2DP, AVRCP |
| Output | 3.5mm AUX |
| Battery | Yes |
The RED LED indicator flashes when the battery is low, indicating charging is necessary.
Press and hold the Multifunction Button for 3 seconds to turn the device on or off.
BR1008 automatically attempts to pair with previously connected devices when powered on.
Steps to pair Bluetooth devices in TX mode, with LED flashing blue and red alternately.
Set BR1008 to RX mode, turn on, and tap MFB twice for pairing mode.
To Next Page
