4
b. Indicator light stops ashing up during oine duplicating: it might
because of disk bad sectors so that data couldn’t be cloned as usual.
It’s better to change a good disk.
c. After cloning, the rest capacity of B disk is showed and operated via
“Computer management - Storage - Disk management”.
d. Why over 2TB hard disk couldn’t be identied by USB? Because the
maximum capacity of hard disk which Windows XP can supports is 2TB
and couldn’t be identied by system if over 2TB. It only supports after
upgrading the operating system above Vista (64 bit) version and we
suggest changing hard disk into a GPT disk partition, or the operating
system will not support over 2 TB disk partitions.
e. Please make sure that B hard disk data can be covered before cloning
data. Because once you start cloning, B hard disk partition methods
and data are completely cloned as A hard disk. Our company does NOT
undertake any responsibility for data or economy loss which could
bring by damaged data.
f. Please do not remove your hard drive or insert a new one while
the other hard drive is being accessed, as doing so the other drive
temporarily disconnects and this could damage your hard drive and
result in data loss.
Support
For any inquiries or comments concerning our products, please send an
email to support@inateck.com, and we will respond to you as soon as
possible.
To Next Page
Loading...
