CARE AND CLEANING
Keep your INCINOLET clean to prevent odors.
• Empty ashpan daily, (or when ash is no more than 1/2 inch deep). EXCESSIVE ASH BUILD-UP CAUSES ODOR,
SHORTENS HEATER LIFE, AND DECREASES EFFICIENCY. If ash is caked and hard to remove,
just soak insert pan for a few minutes in warm water.
• Wipe up urine spills as they happen.
• Every 3 to 6 months – clean blower wheel and inside of INCINOLET.
1. Unplug toilet and remove top. (See instructions below.)
2. Clean inside with a detergent or a spray cleaner such as Formula 409.
(Do not use pine oil cleaners.)
3. Remove blower wheel and clean. (See page 10.)
4. DO NOT STEAM CLEAN.
5. Stainless steel polish can be used on outside surfaces to keep INCINOLET’s finish lustrous.
Bowl Liners
BE SURE that the top edges of the liner are below the lid when it closes. Otherwise, paper will burn outside the
chamber and cause momentary smoke and odor. CAUTION: Failure to use bowl liner for each and every use will
always
cause odor and urine on the floor.
Bowl liners are made of a special paper coated with polyethylene film. This liner is necessary to catch and contain the
waste, then convey it into the incineration chamber. USE A BOWL LINER FOR EACH AND EVERY USE. Liner
protects the bowl and prevents urine from draining to the floor.
How to Remove Ashpan
Remove ashpan only when pan is cool and toilet is not operating.
Removing the Top (Seat, Lid, Bowl Halves)
Top is held in place with four screws, two per side and a rubber boot which protects the start button. Remove them, and
then lift top up.
To replace top: With incinerator lid closed, hold bowl halves together and lower top into position. Replace four screws
and rubber boot over start button. Tip: If you have trouble holding bowl halves in closed position while placing it back
on toilet, just use a small piece of masking tape to hold them together, then slice through it from the top later.
Access Panel
Four screws hold on Access Panel, located on the right side of toilet (same side as foot pedal). Remove panel to expose
blower thermostat, limit thermostat, thermocouple, and heater terminals. (Fig. 12)
7
TO REPLACE ASHPAN
Push ashpan firmly into place.
Lift up on ashpan handle and
engage hook of camloc under
ashpan handle.
Push down on camloc handle.
Replace ashpan panel.
TO REMOVE ASHPAN
Remove ashpan panel.
Raise camloc handle and
unhook it from ashpan
handle. Pull ashpan out.
Empty ash in garbage.
CAUTION: ASHPAN MUST BE SECURELY
IN PLACE FOR PROPER OPERATION.
TIP: If blower becomes
noisy or vibrates, clean
or replace blower wheel.
(See page 10.)
Fig. 7
To Next Page
Loading...
