Indel B TB45A User Manual

19
USE
- Plug in the DC or AC power. Press the button `ON/OFF` to run the refrigerator. The LED display
on the control panel would be lighted and the interior temperature would be displayed.
- Press the button  and  to adjust the temperature. Press the button  to increase while the
button  to decrease the temperature. When press the above two buttons at the same time, it
would switch the display between °C and °F.
- Press the ECO key to enter the "ECONOMY" operating mode: the ECO light turns on and the
compressor runs at minimum speed by keeping a fresh temperature inside the refrigerator. By
pressing the ECO key again, the light turns off and the refrigerator enters in MAX mode (mode
(maximum number of compressor turns). MAX light will be switched on until having achieved
the temperature set.
USEFUL ADVICE
1) Use the product in MAX mode in these cases:
- use of the product as refrigerator with high ambient temperature;
- when the suitable temperature need to be achieved in few time.
2) Use the product in ECO mode in these cases:
- use of the product as refrigerator and, in particular, with low ambient temperature;
- when the vehicle is parked for long time (with engine switched off)
FILLING
Do not put hot food items into the refrigerator. Place the products in such a way as to avoid them
hitting against each other or breaking because of the movement of the vehicle.
Make sure that the lid is always well closed and open it for as short a time as possible.
DEFROSTING
Defrosting is needed when the layer of frost is thicker than 4 mm.
To carry out this operation, turn off the refrigerator.
Do not use sharp or cutting tools to remove the layer of frost or ice.
Wait until complete unfreezing and then turn on again.
TB45A
TB55A
TB31A
TB41A
TB51A
TEMPERATURE
ECO
MAX
MAX
ECO
ON/OFF
189A0746
TEMPERATURE
ECO
MAX
MAX
ECO
ON/OFF
189A0674
ENGLISH

Indel B TB45A Specifications

General

Brand	Indel B
Model	TB45A
Category	Cooling boxes
Language	English