Indesit DFE1B19 User Manual (English)

Questions and Answers:

R
Ricardo SteinJul 27, 2025
Why my Indesit Dishwasher won’t start or respond to commands?
- J
  Joshua DuranJul 27, 2025
  If your Indesit Dishwasher won't start or respond, there might be a few reasons. First, ensure the dishwasher is properly plugged into the socket. If there was a power outage, press the START/Pause button to resume the cycle. Make sure the dishwasher door is fully closed until you hear a click. If the door was opened during a cycle for more than 4 seconds, close it and press START/Pause. If it still doesn't respond, try switching the appliance off and on again after a minute. If the problem continues, unplug it for a minute and then plug it back in.
D
Dana JonesJul 31, 2025
What to do if Indesit DFE1B19 leaves dishes not clean?
- N
  Nancy BurtonJul 31, 2025
  If your Indesit Dishwasher isn't cleaning dishes properly, several factors could be at play. Ensure that the crockery is arranged correctly so the spray arms can rotate freely. Select the appropriate wash cycle for the load. Check that you're using the correct amount of detergent and that it's suitable for dishwashers. Make sure the rinse aid compartment cap is closed properly. Also, a soiled or clogged filter can cause this issue, so clean the filter assembly. Finally, check the salt reservoir and fill it if it's empty.
C
craigkennethAug 4, 2025
Why my Indesit DFE1B19 Dishwasher won’t drain?
- A
  Austin LucasAug 4, 2025
  If your Indesit Dishwasher won’t drain, it could be due to several reasons. First, wait until the wash cycle finishes. Check the drain hose to ensure it is not bent. Also, inspect the sink drain pipe for any blockages and clean it if necessary. Lastly, the filter might be clogged with food residues, so clean the filter.
C
Carlos MartinezAug 9, 2025
What to do if Indesit Dishwasher does not fill the water and all LEDs are blinking?
- L
  Larry WilliamsAug 9, 2025
  If your Indesit Dishwasher isn't filling with water and all the LEDs are blinking, check the following: ensure that there is water in the water supply and that the tap is open. Also, make sure the inlet hose isn't bent. Finally, check the sieve in the water inlet hose for clogs and clean it if necessary. After checking and cleaning, turn the dishwasher off and on, then restart a new program.
D
David RodriguezAug 13, 2025
How to reduce excessive noise from Indesit Dishwasher?
- C
  Courtney GarrettAug 13, 2025
  If your Indesit Dishwasher is making excessive noise, it could be because the dishes are rattling against each other; in this case, position the crockery correctly. Another cause might be an excessive amount of foam. If so, the detergent has not been measured out correctly or it is not suitable for use in dishwashers. Restart the dishwasher by pressing the DRAIN button and run a new program without detergent.
A
Andrea CollinsAug 17, 2025
Why Indesit DFE1B19 finishes the cycle prematurely?
- K
  kevinrogersAug 17, 2025
  If your Indesit Dishwasher is finishing cycles too early, it might be due to the drain hose being positioned too low or siphoning into the home sewage system. Check that the end of the drain hose is at the correct height. Also, inspect the water supply for leaks or other issues letting air inside.
C
Carol HawkinsAug 22, 2025
Why is the salt indicator lit on my Indesit DFE1B19?
- M
  marthawilliamsAug 22, 2025
  If the salt indicator is lit on your Indesit Dishwasher, it means the salt reservoir is empty. Refill it with salt. Note that the indicator may remain lit for several wash cycles after refilling. Also, adjust the water hardness according to the table.

Indesit DFE1B19 Specifications

General

Type	Freestanding
Energy Efficiency Class	F
Number of Place Settings	13
Noise Level	49 dB
Water Consumption per Cycle	12 L
Dimensions (H x W x D)	85 x 60 x 59 cm
Control Panel Colour	White
Noise Emission Class	C
Number of Washing Programs	6
Washing Class	A
Drying Class	A
Energy Consumption per 100 Cycles	104 kWh
Annual Energy Consumption	295 kWh
Annual Water Consumption	3360 L
Delay Start	Yes
Half Load Option	No