Operating Instructions – Washer dryer Indesit IWDE12
Control Panel
Starting a wash cycle
1. Switch the washer-dryer on by pressing . All the LEDs will light up for a few seconds and the On-Off/Door
Lock Led will begin to flash.
2. Load your laundry into the washer-dryer and shut the appliance door.
3. Set the Programme knob to the programme required.
4. Set the wash temperature
5. Set the drying cycle if necessary
6. Add the detergent and any fabric softener
7. Start the programme by pressing the Start/Reset button. To cancel it, keep the Start/Reset button pressed for at
least 2 seconds.
8. When the programme is finished, the On-Off/Door Lock LED will flash to indicate that the appliance door can be
opened. Take out your laundry and leave the appliance door ajar to allow the drum to dry thoroughly. Turn the
washer-dryer off by pressing button
To Next Page
Need help?
General
