What to do if my Indesit WD 10 Washer/Dryer fails to start?
If your Indesit Washer/Dryer isn't starting, try these steps: * Ensure the plug is correctly inserted into the socket. * Check if the On/Off button is pressed. * Verify there is electricity in the house. * Confirm the programmed start knob is in the correct position (if applicable). * Make sure the washer-dryer door is closed properly.
Why Indesit Washer/Dryer does not drain or spin?
If your Indesit Washer/Dryer isn't draining or spinning, consider the following: * Check if the selected program includes water draining, as some programs require manual draining selection. * See if the 'Anti-crease' function is enabled, as it may require manual draining selection. * Inspect the drain pump for clogs. Turn off the water supply and unplug the washer-dryer before checking. * Ensure the drain hose isn't kinked and is as straight as possible. * Verify the washer-dryer’s drain duct isn't clogged.
Why Indesit WD 10 doesn't dry properly?
If your Indesit Washer/Dryer isn't drying properly, check these: * Make sure the end of the drain hose is not underwater. * Check if the drain pump is obstructed. * Confirm you're not exceeding the maximum load capacity. * Ensure the water tap is turned on.
How to reduce excessive vibration during the spin cycle of Indesit WD 10?
To reduce excessive vibration during the spin cycle of your Indesit Washer/Dryer: * Ensure all transit screws have been removed during installation. * Check if the washer-dryer has been leveled correctly. * Verify there is space between the machine and any adjacent units.
What to do if my Indesit Washer/Dryer leaks?
If your Indesit Washer/Dryer is leaking, verify the following: * Ensure the metal ring of the inlet hose is properly attached. * Check if the detergent dispenser is obstructed. * Confirm the drain hose is well attached.
Why Indesit WD 10 Washer/Dryer fails to fill with water?
If your Indesit Washer/Dryer isn't filling with water, check these items: * Ensure the hose is correctly connected to the tap. * Verify there isn't a water shortage. * Check if the tap filter is clean. * Confirm the drain hose isn't positioned too low; it should be between 60 cm to avoid bad odors. * Make sure the rubber hose isn't kinked. * Ensure the end of the hose isn't immersed in water. * Check if the wall drainage system has a breather pipe.
Outlines care, common problems, solutions, and safety guidelines.
Essential steps to perform before contacting technical support.
Solutions for issues related to appliance start-up and water intake.
Addresses issues with the washer-dryer not draining or spinning correctly.
Troubleshooting for draining, spinning, vibration, leaks, and foam.
Guidance for when the appliance does not dry or dries improperly.
Steps to take upon receiving the new washer-dryer.
Instructions for connecting water mains and drain hose.
Details on electrical setup, fuses, and appliance levelling.
Information on fuse covers, plug replacement, and wiring.
Vital safety guidelines for operating the appliance safely.
General| Drying Capacity | 4 kg |
|---|---|
| Spin Speed | 1000 rpm |
| Number of Programs | 16 |
| Type | Washer Dryer |
| Loading type | Front Load |
| Dimensions (H x W x D) | 85 cm x 59.5 cm x 53.5 cm |
To Next Page
