AM280 - Clean collets and base body
Carrying out the maintenance activities described below requires
special knowledge. For this reason, these maintenance activities
must only be carried out by staff that has received adequate training
by the machine manufacturer!
Orientation
The Hainbuch ZW clamping system is used on this lathe. This clamping system is
suitable for square, hexagonal and bar stock. The collets and collet mountings must
be cleaned regularly depending on the machine utilization, the type of machining,
and the materials used. Hainbuch offers various tools for removal and installation.
Example: Clamping head (Hainbuch)
Example: Manual and hydraulic changing device (Hainbuch)
Requirement
Due to different requirements and/or specifications of the respective
manufacturers, be sure to review the respective manufacturer's
documentation!
To clean the collets, sufficient quantities of cleaning agent such as benzine as well
as grease (oil-resistant) for greasing the collets are necessary. For the operating
Maintenance Summary - Care activities
37
Maintenance Instructions
MS32-6.2
DIM012EN - 03.06.2020
To Next Page
Loading...
