Industrial Scientific GasBadge Pro Quick Start Guides

NOTE: This reference sheet is a supplement
to the GasBadge Pro manual (part number
17123100) and is not intended to be used as a
replacement for the information in the manual.
For other language versions of this quick start
guide, go to www.indsci.com.
Personal
Single Gas
Monitor
Mode
Button
(
On/Off
)
ACTIVATION
Instrument
Firmware
Version
Countdown
After
Activation
Gas
Monitoring
Screen
IMPORTANT: A function or "bump" test, using a
known concentration of calibration gas, should be
performed periodically based on instrument use,
exposure to gas, and environmental conditions.
The frequency is best determined by company
policy or local regulatory agencies. If an
instrument fails a function or "bump" test, or, if it is
dropped, submerged, or appears damaged, a full
calibration is recommended. The safest
approach is to perform a function or "bump" test
prior to each day's use. Industrial Scientific is not
responsible for establishing customer safety
p
ractices and
p
olicies.
MONITOR MODE
Quick Start Guide
Up
Button
Down
Button
Time Weighted
Average
Reading (TWA)
Short Term
Exposure Limit
Reading (STEL)
Create New
Session
Enter
Button
Part Number: 17126368
Revision: 3.0
Release Date: 01-02-2009
© 2005 Industrial Scientific. All rights reserved.
Gas
Monitoring
Screen
Days Since/Until
Calibration (if
enabled)
Zero Initiate
Bump Test
Initiate (if
enabled)
Peak Reading

Industrial Scientific GasBadge Pro Specifications

General

Brand	Industrial Scientific
Model	GasBadge Pro
Category	Measuring Instruments
Language	English