What to do if Industrial Scientific Measuring Instruments unit does not respond to gas?
If your Industrial Scientific Measuring Instrument isn't responding to gas, here's what you can do: * First, examine the sensor opening for any dirt or debris and clean the sensor opening. * Second, replace the sensor patch. * Third, calibrate the instrument.
Why is the display blank on my Industrial Scientific GasBadge Pro Measuring Instruments?
If the display of your Industrial Scientific Measuring Instrument is blank, it could be due to the following reasons: * The instrument has not been activated. Activate the instrument. * There is no power. Ensure the power supply is connected.
General| Display | LCD |
|---|---|
| Vibrating Alarm | Yes |
| IP Rating | IP66/67 |
| Data Logging | Yes |
| Sensors | Electrochemical |
| Operating Temperature | -20 to 50 °C (-4 to 122 °F) |
| Audible Alarm | 95 dB at 10 cm |
| Visual Alarm | Yes |
| Sensor Types | Electrochemical |
| Alarms | High, Low, STEL, TWA |
| Certifications | ATEX, IECEx |
| Operating Humidity | 0 to 100% RH |
Details on configuration, bump testing, zeroing, and calibration for instrument maintenance.
The screen displayed after activation, showing a decrementing countdown.
Setting low, high, TWA, and STEL alarm thresholds for gas detection.
Common issues and their likely causes for the GasBadge Pro instrument.
Understanding battery failure, sensor missing, and unexpected instrument errors.
Step-by-step instructions for replacing the instrument's sensor.
To Next Page
