iNetVu 7000 Series Manual

INETVU® MOBILE SYSTEM QUICK START – GILAT CAPRICORN-4
1.5 Initial Controller Configuration and Verification with Gilat
Once the system wiring with the Gilat modem is setup and the network configuration on your PC is
configured, you are required to configure the system parameters for the following before satellite
acquisition:
 Communication Method between IMS and iNetVu® Controller.
 Satellite Name, Longitude, and Transmit Polarization
 Modem/VSAT Communication Parameters
The 7000 Controller may be configured via the Software Application / Web Interface / LCD interface.
Only one is necessary for complete configuration.
 iNetVu® Software Application (preferred method)
 First time user should use the iNetVu Wizard which is imbedded into the iNetVu software for
guidance in configuring your system.
▪ USB Connection (preferred method)
▪ Ethernet Connection
 iNetVu® Web Interface
▪ Ethernet Connection
 iNetVu® 7000 Front Panel
USB drivers must be installed for USB connection method. The configuration process is only required to
be done once as long there are no change in satellite, service, modem, or platform parameters.

iNetVu 7000 Series Specifications

General

Brand	iNetVu
Model	7000 Series
Category	Controller
Language	English