Need help?Do you have a question about the iNetVu 7000 Series and is the answer not in the manual?
General| Interface | Ethernet |
|---|---|
| LNB Power | 13/18 VDC |
| Frequency Range | 950-2150 MHz |
| Input Level Range | -65 to -25 dBm |
| Modulation Support | QPSK, 8PSK |
| Symbol Rate Range | 1-45 Msps |
Step-by-step guide for installing the iNetVu® software and necessary USB drivers.
Guide to the setup wizard process for configuring the system upon first launch.
Explains the function of buttons for FIND SAT, STOP/STOW, and manual movements.
Details real-time status for Elevation, Azimuth, and Polarization angles and limits.
Shows GPS, Compass, Satellite, Modem, and Beacon Receiver status information.
Explains how to find satellites and enable/disable the transmitter.
Details procedures for Azimuth, Polarization, and Compass calibration.
Configures target satellite parameters, including longitude and polarization offset.
Configures RF search modes, compass, AZ window, and modem beam IDs.
Configures parameters for using a reference satellite in search operations.
Configures target and reference satellite parameters, including longitude and transponders.
Configures modem, beacon receiver, controller IP, and network settings.
Sets search methods, parameters, and LNB frequency settings.
Step-by-step instructions for updating the controller firmware via the web interface.
Procedure for updating the satellite transponder data table on the controller.
To Next Page
