iNetVu 7000 Series User Manual

C-COM Satellite Systems Inc. Page 18 of 164
6. Installation
The iNetVu
®
7000 Series Controllers are shipped pre-configured and calibrated with the
iNetVu
®
Mobile Platform and service which you plan to use. Only configuration of the
Satellite Modem / VSAT Communication parameters and the satellite you wish to find is
required.
***Note: controllers may have 4 or 5 digit serial number which is required to be entered
for correct default configuration values.
6.1. Rack Installation
The iNetVu
®
7000 Series Controllers include attachable “ears” which make the iNetVu
®
7000 Series Controllers configurable for rack-mounted installation.
If you are installing the iNetVu
®
7000 Series Controller onto a rack, ensure that you use
supporting rails or a shelf to support the weight of the iNetVu
®
7000 Series Controller,
and use the provided “ears/brackets” to fasten the unit to the rack face.
6.2. iNetVu
®
Software – Software and USB Driver Installation
It is recommended that the previous software be uninstalled before installing latest
software version if upgrading. See minimum recommended pc requirements for most
favorable working system.
Note: The application will exit if controller communication is via USB and Modem
Configuration Type is set to HN_KA during any power recycle or loss of
communication (cable unplugged) without warning. This will NOT hold true if
controller is in Firmware update mode. More info under Maintenance Menu
Buttons section.

iNetVu 7000 Series Specifications

General

Brand	iNetVu
Model	7000 Series
Category	Controller
Language	English