C-COM Satellite Systems Inc. Page 12 of 164
5. Typical Connection Configuration
The typical connection configuration for each service will be the same regardless of the
Satellite Modem / VSAT. However, the configuration parameters for Satellite Modem /
VSAT Communication will differ depending on service. See iNetVu
®
System Manual for
configuration procedures corresponding to the service used.
This situation or practice might result in property or
equipment damage. Ensure Sensor and Motor cables
are connected prior to powering on 7000 Series
Controller. Do not connect or disconnect cables once
controller has been powered on. It is recommended
that controller is properly grounded at all times
NOTE: The 7000C/7024C controllers must use the GLONASS/GPS antenna that
was shipped with the system for optimal GPS signal reception.
To Next Page
Loading...
