iNetVu 7000 Series User Manual

C-COM Satellite Systems Inc. Page 106 of 164
8.2.2.6. PC Application
This sub-section contains options regarding the relevant IP address connection to the
iNetVu
®
Series 7000 Controller. This section allows user to enter IP address of the
desired controller they wish to connect to over the network.
Fig. 86: PC Application Parameters
Controller IP Address (For Remote Connection)
User can enter IP address of networked controller and connect to it over the Network.
Com Port
Used in conjunction with the serial port interface (Interface parameter under COM Port
Configuration section) communication between the controller and pc.
Log Data
The user may choose to upload either 1 hour, 2 hours, or ALL (maximum of 12 hours) of
the recorded data log information from the controller to the PC.
8.2.2.7. Site Name and Controller Beep
Site Name
Site Name in the controller that consists of combination of letters and numbers up to 30
characters. Site Name will be displayed in the browser tab when using the web interface.
BEEP
This checkbox is used to either enable or disable the beeping noise when navigating the
LCD interface on the iNetVu
®
7000 Series Controller. Selected option implies beeping
sound is enabled unless D (disabled) is selected.
Disabled – Beep Disabled, the sound will be completely muted.
Low – Beep Enabled, a beeping sound will occur every 2 seconds.
Medium – Beep Enabled, a beeping sound will occur every 1 seconds.
High – Beep Enabled, a beeping sound will occur every 500 milliseconds.

iNetVu 7000 Series Specifications

General

Brand	iNetVu
Model	7000 Series
Category	Controller
Language	English