C-COM Satellite Systems Inc. Page 48 of 164
8 – Compass Restore (CR)
Restores the compass to the factory calibrated default state as was shipped from
the manufacturer. Use this button only after consulting with C-COM Support.
7.6.3. CONF1
This Menu will allow the user to configure and save all 5 Satellites with 5 beacon settings
as well as other configurable Search Modes of the iNetVu
®
System. A description of
each menu and their purpose is outlined below. This section explains the different sub-
menus of the configuration (CONF1) menu, and what each field parameter means.
7.6.3.1. Password Protection
The LCD Configuration Interface is password protected.
Fig. 31: Password screen
The default password is “password” (case sensitive).Use the “↑” or “↓” button to
select the characters, and the “←” or “→” to navigate through the character fields. Press
on the “ENTER” button of the front panel when the password has been completely
entered.
If the password has been changed, and the user does not know the password, entering
a specific reset ID in the bottom row will reset the password to the default (“password”).
The Reset ID (RST) is “123456789”
7.6.3.2. Configuration Menu (CONF1)
Fig. 32: CONF1 (Configuration) Menu
PWD:: ********
RST :: *********
To Next Page
Loading...
Need help?
General
