What to do if infaco Electrocoup F3015 pruning shears do not start with sufficient conductivity?
If your Infaco Power Tool pruning shears do not start despite sufficient conductivity, repeat the calibration steps. Ensure you release the trigger before breaking contact between the bottom of the hook and your hand and/or glove.
How to resolve insufficient conductivity during calibration of Infaco Power Tool, causing pruning shears not to start?
If you're experiencing insufficient conductivity during the calibration of your Infaco Power Tool, and the pruning shears won't start, consider these steps: * Ensure you are wearing an INFACO conductive glove to enhance conductivity. * The glove may be damaged; consider replacing it. * Clean the glove by hand using clean water without detergent, and allow it to dry completely before recalibrating. * Repeat the calibration process twice, testing one glove at a time by removing one glove and then the other.
General| Battery Type | Lithium-Ion |
|---|---|
| Battery Voltage | 48V |
| Cutting Capacity | 40mm |
| Cutting Diameter | 40mm |
| Type | Electric Pruning Shear |
| Voltage | 48V |
To Next Page
