Position the lap section of the vehicle seat across the
child’s lap then insert the buckle tongue in to the belt
buckle until you hear “CLICK”. Ensuring the lap
portion is positioned under the armrests and over the
child’s thighs (refer Figure 3).
Refer to shoulder height marker (As shown on
pages 5 and 6).
IMPORTANT
!
The red “Booster Seat belt Path” labels are located
each side of the Booster seat and on the head rest.
Use
Using lap-sash seat belt
Booster Car Seat
IMPORTANT
!
Ensure that you use the
BOOSTER
SEATBELT
PATH
identied by the following label.
BOOSTER BELT PATH
Figure 1
Figure 2
Figure 3
Sit your child in the restraint with their back against
the backrest adjust the headrest as described in setup
to best suit your child (refer Figure 2).
Ensure the restraint has been installed as per
“INSTALLING IN VEHICLE” (refer Figure 1)
Check the position of the headrest and adjust
if needed (refer Page 9).
Thread the sash belt through the sash guide on
the bottom of the headrest.
“CLICK”
13
To Next Page
Loading...
