Run and Test
After code compilation and flashing the device, perform the following steps:
› Run the project and check if the LED
D110 is on.
– Data transmitted without errors
› Additionally, using the debugger, the
behavior can be checked:
– Add g_qspiDma to Watch window
– Check if
g_qspiDma.qspiBuffer.spiSlaveRxBuffer and
g_qspiDma.qspiBuffer.spiMasterRxBuffer
are the same as
g_qspiDma.qspiBuffer.spiMasterTxBuffer and,
respectively,
g_qspiDma.qspiBuffer.spiSlaveTxBuffer
LED
D110
11
2020-01-17 Copyright © Infineon Technologies AG 2020. All rights reserved.
To Next Page
Loading...
