DRAINAGE
1.
Water tank
When the water tank is full, the light on the control panel will flash. The device
will
stop working, the buzzer will sound 10 times and then it will stop but the light
indicator will stay on. Take off the water tank to empty the water and install the
water tank like the images below.
2.
Connuous drainage
The water can be drained continuously by connecting a water pipe in the back (the
inner diameter is 9mm). Please check if the pipe is stably connected with the
drainage mouth to avoid water flowing out.
Note:
please ensure that the water pipe will not be too long (usually 1 m ore 1.5m)
and the height cannot surpass the height of drainage mouth to avoid water leakage.
Note:
before putting back the water tank, please ensure the float is flexible.
To Next Page
Loading...
