Infiniton GASDL4 - Page 32

inniton.es34
English
Installation
Gas conversion
• Exercise caution in operations and adjustments when converting from one gas to another.
• This work must be carried out by a qualied technician.
• Before starting, turn off the gas and electrical power to the appliance.
1. Replace the burner nozzle
Remove the pot support, burner cap and ame spreader.
Unscrew the injector with a 7 mm spanner and replace it with the injector stipula-
ted for the new gas ow. After replacement, it is advisable to tighten the injectors in
place.
2. Adjust the minimum ame level
Turn the knob to the minimum.
Remove the knob inside the spanner shaft and tighten the small screw in the centre
of the spanner shaft. The correct setting is obtained when the ame is approximately
3-4 mm long.
* For butane/propane gas, the screw adjustment must be correctly
tightened.
correctly tightened.
* Replace the key in the knob.
* Make sure that the ame does not go out quickly when going from
maximum to minimum.
Make sure that the ame does not go out quickly when switching from
maximum to minimum.
Repeat this process for each of the gas connections.
• According to the law, all gas equipment must be installed by competent persons in accordance with
current legislation on safety of installations and rules of use.
• Make sure that you comply with the law.
G30 29mbar
G20 20mbar
0.91
1.39
/
/
/
/
0.50
0.78
Gas type &
pressure
Model
Heat input and orifice size marked(mm)
Wok burner
3.3kW(240g/h) 3.0kW(218g/h) 1.75kW(127.5g/h) 1.0kW(73g/h)
Rapid burner Semi-rapidA uxiliary-rapid
GAS-CR2B
GAS-IX02
G30 29mbar
G20 20mbar
0.97
1.41
/
/
0.66
1.00
0.50
0.78
GG-331
GG-332
G30 29mbar
G20 20mbar
0.93
1.28
/
/
0.66
1.00
0.50
0.78
GAS-320WB
GG-429
G30 29mbar
G20 20mbar
/
GASDL4
/
0.87
1.30
0.66
1.00
0.50
0.78
GGMCI-315
GAS419H
Control knob
Adjustement screw
Seal ring
Injector