Installation (supplement)
1. The switching operation of this microwave oven can cause voltage fluctuations on the
supply line. The operation of this oven under unfavorable voltage supply conditions can have
adverse effects. This device is intended for the connection to a power supply system with a
maximum permissible system impedance Zmax of smhO 2 3.0 at the interface point of the
user’s supply. The user has to ensure that this device is connected only to a power supply
system which fulfills the requirement above. If necessary, the user can ask the
public power
supply
company for the system impedance at the interface point.
2. If there is no equipotential bonding conductor in the electric supply, an external
equipotential bonding conductor must be installed at the rear of the appliance (see symbol).
This terminal shall be in effective electrical contact with all
fixed exposed metal parts and shall allow the connection of a conductor having a nominal
cross-sectional area up to 10 mm².
Symbol for the external connection of equipotential bonding conductors.
Symbol for the external connection of equipotential bonding conductors.
To Next Page
Loading...
