Infinity ENTRA SUB TWO - SPECIFICATIONS

6
ENTRA SUB TWO
If your receiver/processor does not have
subwoofer outputs for the left and right
channels or an LFE output:
SYSTEM CONNECTIONS
If your receiver/processor does not contain a Dolby Digital
or DTS processor but has a subwoofer output:
Set line-level/LFE switch to “Normal.”
NOTE: If your receiver/processor has only one sub out,
you may use either the L or R input.
If you have a Dolby* Digital or DTS
®
receiver/processor
with a low-frequency-effect (LFE) or subwoofer output:
Entra Sub Two
120V
60Hz
CROSSOVER
FREQUENCY
LEVEL
LINE LEVEL IN
PHASE
Min
Max
L
R
L R
For LFE use L or R
LFE NORMAL
HIGH
LEVEL
IN
L
R
HIGH
LEVEL
OUT
+ –
50Hz
0º 180º
150Hz
POWER
ON OFF
RECEIVER/AMPLIFIER
Front Speaker Output
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
AVERTISSEMENT: POUR PR VENIR LES RISQUES D’INCENDIE OU DE CHOC
LECTRIQUE, VITER D’EXPOSER CET APPAREIL A LA PLUIE OU A L’HUMIDIT .
NTRL/C
CSA 22.2
UL1492
80Hz
Green: On
Red: Stand-By
CROSSOVER
FREQUENCY
LEVEL
LINE LEVEL IN
PHASE
Min
Max
L
R
L R
For LFE use L or R
LFE NORMAL
HIGH
LEVEL
IN
50Hz
0º 180º
150Hz
RECEIVER/PROCESSOR
80Hz
L R
Green: On
Red: Stand-By
CROSSOVER
FREQUENCY
LEVEL
LINE LEVEL IN
PHASE
Min
Max
L R
For LFE use L or R
LFE NORMAL
50Hz
0º 180º
150Hz
SUBWOOFER OR
LFE OUTPUT
80Hz
Green: On
Red: Stand-By
Set line-level/LFE switch to “LFE.”
LOOSEN TERMINALS
INSERT BARE END;
TIGHTEN TERMINALS
1.
2.
BLACK =
–
NO STRIPE = – STRIPE = +
RED = +
This figure shows how to connect bare wires to the terminals.
Banana plugs may also be inserted directly into the rear of
the connector.
Entra Sub Two