2
ATTACHING THE LEGREST
Move the legrest over to the front of the chair. Attach the air hose to
the air nozzle, marked with the yellow arrow below. Attach the two
power cables to the connectors, marked with red arrows. Make sure
the thumb release lines up with the right side of the connectors so
they lock in.
ATTACHING THE ARMRESTS
5
Next, carefully insert the alignment nub on the arm with the
corresponding socket on the chair body. Bump it into place and make
sure it is secure:
Now tighten the Phillips screw on the hole of the arm until tight.
Replace the rubber plug in place and repeat on the other armrest:
Finally, zip the backrest into place and put the velcro pillow in place.
To Next Page
Loading...
