To Next PageTo Next Page
Need help?Do you have a question about the Infinity Smart Chair and is the answer not in the manual?
General| Reclining | Yes |
|---|---|
| Zero Gravity | Yes |
| Bluetooth | Yes |
| USB Charging | Yes |
| Adjustable Intensity | Yes |
| Foot Rollers | Yes |
| Remote Control | Yes |
| Massage Type | Shiatsu, Kneading, Tapping, Rolling |
| Airbags | Yes |
| Massage Areas | Back, Shoulders, Legs, Feet |
| Power Supply | AC 110-240V |
Open the main box, place the chair body, unscrew bolts from the left side, and connect air hoses from the left armrest.
Latch the left armrest to the pin, push it forward, unzip the cover, remove the plastic part, and reassemble.
Unscrew screws from the armrest and install the remote holder. Repeat for the right armrest.
Remove the legrest from packaging, position it in front of the chair body, and connect power and air hoses.
Insert hex screws through bolt holes on the legrest to fasten it to the massage chair body on both sides.
Zip the legrest to the seat cushion to finalize the installation.
Zip the back cushion to the backrest. Connect numbered air hoses (5-5, 6-6, 11-11) on the left side.
Connect the air hose (12-12) and power cable on the right side of the back cushion.
Connect the white speaker connector to the chair's white connector until it clicks.
Insert 3 joint pins into matching tubes on the chair, expose and tighten the locking screw, then cover it.
