[ Edit: 2016/ 8/ 1 Model: 2017MY INFINITI Q70(Y51) OM17E00Y51U0 ]
SSD1002
3. Highlight the “Blind Spot Intervention”
key, select ON (enabled) or OFF (dis-
abled) and push the ENTER button
*
2
.
For the LDP and DCA systems, see “Lane
Departure Warning (LDW) /Lane Departure
Prevention (LDP)” (P.5-24) and “Distance
Control Assist (DCA)” (P.5-94).
BSI SYSTEM LIMITATIONS
GUID-0685AC7B-A996-40A3-9ACF-9C09F0C16E2B
WARNING
Listed below are the system limitations for
the BSI system. Failure to operate the
vehicle in accordance with these system
limitations could result in serious injury or
death.
. The BSI system cannot detect all vehi-
cles under all conditions.
. The radar sensors may not be able to
detect and activate BSI when certain
objects are present such as:
—
Pedestrians, bicycles, animals.
—
Vehicles such as motorcycles, low
height vehicles, or high ground
clearance vehicles.
—
Vehicles remaining in the detection
zone when you accelerate from a
stop.
—
Oncoming vehicles.
—
A vehicle merging into an adjacent
lane at a speed approximately the
same as your vehicle.
—
A vehicle approaching rapidly from
behind.
—
A vehicle which your vehicle over-
takes rapidly.
—
A vehicle that passes through the
detection zone quickly.
. The radar sensor’s detection zone is
designed based on a standard lane
width. When driving in a wider lane, the
radar sensors may not detect vehicles in
an adjacent lane. When driving in a
narrow lane, the radar sensors may
detect vehicles driving two lanes away.
. The radar sensors are designed to ignore
most stationary objects, however ob-
jects such as guardrails, walls, foliage
and parked vehicles may occasionally be
detected. This is a normal operation
condition.
. The camera may not detect lane markers
in the following situations and the BSI
system may not operate properly.
—
On roads where there are multiple
parallel lane markers; lane markers
that are faded or not painted clearly;
yellow painted lane markers; non-
standard lane markers; lane markers
Starting and driving 5-49
Condition: