•
If any abnormalities are found or the heating does
notoperate, turn off the switch and have the sys-
tem checkedbyanINFINITI Centre or qualified
workshop.
The front seats are warmed by built-in heaters.
The switches are located on the centre console
andcan be operated independently,for the left-
hand side seat and for the right-hand side seat.
Thethree red indicator lights in the button indi-
cate theheating level youhave selectedThe sys-
tem automaticallyswitchesfrom level 3tolevel
2after approximately eight minutes The system
automatically switches from level 2tolevel 1af-
ter approximately ten minutes. The system au-
tomatically switches off approximately 20 min-
utes after it is set to level 1
1. Turn the ignition switch to the ON position.
NOTE
The seat heater canonlybeactivated when the
ignition switch is in the ON position.
2. Startthe engine.
3. Select the heat range:
•
To switch on: pressbutton j1repeatedly until
the desired heating level is set.
•
To switch off: pressbutton j1repeatedly until
allthe indicator lights turn off.
NOTE
If thebatteryvoltageistoo low, the seat heating may
switch off.
WARNING
•
If youuse the memoryfunction on thedriver’s side
while driving, the adjustments could causeyou to
lose control of the vehicle. There is ariskofan
accident. Only usethe memoryfunction on the
driver’s side while the vehicle is stationary.
Only usethe memoryfunction on the driv-
er’sside while the vehicle is stationary.
•
If the memoryfunction adjusts the seat, youand
othervehicle occupants-particularly children-
could become trapped. There is ariskofinjury.
Whilethe memoryfunction ismaking adjust-
ments, make sure that no one has anypart of
their body within the sweep of the seat. If
someonebecomes trapped, immediately re-
leasethe memoryfunction position button
The adj
us
tment
is
stopped.
NIC2634
NIC2637
MEMORY FUNCTION (where fitted)
2-70 Instruments and controls
To Next Page
Loading...