Repairing tyre
1. Shakethe sealant bottle well
j
1.
2. Attachthe hose from the compressor to the
sealant bottle
j
2.
3. Slide the sealant bottle into the holder on
thetop of the compressor
j
3.
4. Remove the speedrestriction stickerfrom the
compressor,then placeitinalocation where
the driver cansee it while driving.
5. Screwthe air tube from the sealant bottle
j
4
securely onto thetyre valve. Makesure that
theair compressor switch is in the “OFF” (0)
position.
6. Insertthe compressor power plug into the
power outlet in the vehicle. Make sure no
other accessories are fitted to the power out-
let. Fordetails, see
“Power outlet” in the “2. In-
struments and controls” section
.
7. Turn the ignition switch to the ACCposition.
8. Switch on the compressor,and inflate the
tyre to thepressure that is specified on the
tyreplacard affixedtothe driver’sside centre
pillar.
CAUTION
Do notoperate the compressor for more than 10 min-
utes.
If thetyre pressure does not increasetothe
specified pressure within 10 minutes,the tyre
maybeseriously damagedand thetyre cannot
be repaired with thistyre repair kit.Contact an
INFINITI centre or qualified workshop.
9. Remove the air compressor from the tyre
valve. Immediately drive the vehicle at a
speed of 80 km/h(50 MPH) or less.
10.After a10minute or10km(6miles) drive,
checkthe tyre pressure. The temporaryre-
pair is completed if the tyre pressure does
not drop.
If thetyre pressure is lower than specified,
repeat the stepsfrom step 5.
NCE456
NCE457
NCE458
6-6 In case of emergency
To Next Page
Loading...