If the pressure dropsagain or under 180kPa
(1,8 bar, 26 psi), thetyre cannot berepaired
with thistyre repair kit.Contact an INFINITI
centre or qualified workshop.
After repairing tyre
See an INFINITI centre or qualified workshop for
tyre repair/replacement, inspection/replace-
mentofthe TPMSsensor and for anew tyre seal-
ant bottle and hose, as soon as possible.
REMOVING AND FITTING WHEELS
Blockingthe wheels
WARNING
Makesure to blockthe appropriate wheel to prevent
the vehicle from moving, whichmay causepersonal
injury.
Placesuitable blocks
j
1infront of and behind
thewheel diagonallyopposite the flat tyre
j
Ato
prevent the vehicle from moving when it is on
thejack.
Removing wheel cover (where fitted)
WARNING
Take care when removing the wheel cover as the cover
maydetachsuddenly.
Remove the wheel cover as illustrated with a
suitabletool or carefully remove the wheel cover
with both hands.
Removing the wheel
WARNING
•
Makesure to read the caution label attached to
thejackbody before use.
•
DO NOTGET UNDER AVEHICLE THATISSUPPORTED
BY AJACK.
•
Neveruse ajackwhichwas not provided with your
vehicle.
•
Thejackwhichisprovided with your vehicle is de-
signed only to lift your vehicle during atyre
change.
•
Usethe correctjacking points.Never useany other
partofthe vehicle for jack support.
•
Never lift the vehicle more than necessary.
•
Never useblocks on or under the jack.
•
Do not startorrun the engine while the vehicle is
on the jack.The vehicle maymovesuddenly,and
thismay causeanaccident.
•
Never allow passengerstostayinthevehicle while
the tyre is off the ground.
•
Make sure to read the caution label attached to
thejackbody before use.
•
Remove allloads before lifting the vehicle with the
jack.
MCE0001DZ
NCE453
NCE447
Jack-up points
In case of emergency 6-7
To Next Page
Loading...