Low/High beam Headlight bulb replacement:
1. Open thebonnet. Fordetails, see
“Bonnet
release” in the “3. Pre-driving checks and
adjustments” section
.
2. Disconnect the negative(—)batterycable.
3. Remove the corresponding access cover from
thewheel arch.
4. Turn housing cover
j
1anticlockwiseand re-
move it.
5. Turn bulb holder
j
2anticlockwiseand pull
out
6. Take the headlight bulb out of bulb holder
j
2.
7. Insertthe new bulb into bulb holder
j
2.
8. Insertbulb holder
j
2and turn it clockwise.
9. Press on housing cover
j
1and turn it to the
right.
10.Replacethe cover in the front wheel arch
11. Reconnect the negative (—)batterycable
andclose the bonnet.
NOTE
Fogmay temporarily form inside the lensofthe exte-
rior lights intherain or inacar wash.The fog iscaused
by atemperature differencebetween the inside and
the outside of the lens. Thisisnot amalfunction. If
largedroplets canbeseen, then contact an INFINITI
centre or qualified workshop.
Frontturn signal light bulb
replacement (non-LED system only)
1. Open thebonnet. Fordetails, see
“Bonnet
release” in the “3. Pre-driving checks and
adjustments” section
.
2. Disconnect the negative(—)batterycable.
3. Turn housing cover
j
1anticlockwiseand re-
move it.
4. Turn bulb holder
j
2anticlockwiseand pull
out
5. Take the headlight bulb out of bulb holder
j
2.
6. Insertthe new bulb into bulb holder
j
2.
7. Insertbulb holder
j
2and turn it clockwise.
8. Press on housing cover
j
1and turn it to the
right.
9. Reconnect the negative (—)batterycable and
close the bonnet.
NDI1611
NDI1612
8-26 Maintenanceand do-it-yourself
To Next Page
Loading...