indicator lamp
m
must be lit. Turn the igni-
tion switch to the ON position and make sure
that the front air bag status light
m
illumi-
nates.
2. Move the seat to the rearmost position
j
1.
3. Adjust the head restraint to its highest posi-
tion
j
2.Remove it if it interferes with the
child restraint installation. In suchsitua-
tions, securely store the head restraint in the
luggage compartment so that it does not be-
come adangerousprojectile duringasudden
stop
or in an ac
ci
dent.
4.
Posi
tion the
ch
ild restraint in the seat.
5. Route the seat belt tongue through the child
restraintand insertitinto the buckle
j
3until
youhearand feel the latchengage.
6. To prevent slackinthe seat beltwebbing, itis
necessarytosecure the seatbeltinplacewith
locking devices attached to the child
restraint.
7. Remove any additional slackfrom the seat
belt;pressdownward
j
4and rearward
j
5
firmly in thecentre ofthe child restraint with
your knee to compressthe vehicle seat cush-
ion and seatbackwhile pulling uponthe seat
belt.
8. Test the child restraint before youplace the
child in it
j
6.Push the child restraint from
side to side and tugitforward to make sure
that it is held securely in place.
9. Check to make sure that the child restraint is
properlysecured prior to each use. If the child
restraint is loose, repeat steps5through 8.
SSS0627Z
Steps 2and 3
SSS0360CZ
Step5
SSS0647BZ
Step 7
SSS0302GZ
Step 8
Safety — seats, seat beltsand supplemental restraint system 1-25
To Next Page
Loading...