48
Error Conditions
Not all commands are supported for all projectors. If an unsupported command is issued, the
command will be ignored. If a command is received that is not understood, a ‘?’ character will
be returned indicating the command was not understood.
Limitations
The projector cannot respond to commands coming in at a high-rate. Therefore, a delay must
occur between commands to ensure that the command gets properly executed. To assure the
projector can process a command, wait 3 seconds before entering the next command.
Function
Com
mand
RW Min Max Default Step
AC Power On
0: Disable; 1: Enable
APO RW 0 1 0 1
Active Source
0: HDMI
1: DVI
2: VGA
3: Component / BNC
4: Composite
5: S-Video
6: 3G-SDI
SRA RW 0 6 0 1
Aspect Ratio
0: 5:4
1: 4:3
2: 16:10
3: 16:9
4: 1.8
5: 2.35
6: Letterbox
7: Native
8: Unscaled
AZT RW 0 8 2 1
Auto Off Time
0: Off (never)
1: On (20 minutes)
AOT RW 0 1 0 1
Auto Source
0: Disable; 1: Enable
ASC RW 0 1 0 1
Auto Sync
0: Off
1: On
AIM W 0 1 1 1
Blank Bottom BBO RW 0 360 0 1
Blank Left BLE RW 0 534 0 1
Blank Reset
1: Reset
BRS W 1
Blank Right BRI RW 0 534 0 1
Blank Screen
0: Disable; 1: Enable
BLK RW 0 1 0 1
Blank Top BTO RW 0 360 0 1
Blue Gain BCG RW 0 200 100 1
Blue Offset BCO RW 0 200 100 1
Blue Only
0: Off
1: On
BON RW 0 1 0 1
Brightness BRT RW 0 200 100 1
Center Lens
1: Center Lens
MHC W 1
Color COL RW 0 200 100 1
Color Space
0: Auto
1: YCbCr (REC709)
2: YPbPr (REC601)
3: RGB-PC (0-255)
4: RGB-Video (16-235)
CSM RW 0 4 0 1
To Next Page
Loading...
Need help?
General
