InFocus LightPro IN1046 - Air Ventilation; Place Your Projector Correctly

www.infocus.com
Safety operation guideline
12
Airintake
Air ventilation
Openingsinthecasingaredesignedfor
ventilationandoverheatingprevention.
DONOTblockorcovertheseopeningsto
keepyourprojectorinnormaloperation
andfromoverheating.
Note
Heat exhaust at the air outlet.
Keep the following in mind when
using or installing your projector:
– DONOTplaceammablematerials
orsprayersnearyourprojector.
– Keeptheairoutletonemeteraway
fromotherobjects.
– DONOTtouchtheareacloseto
theairoutletespeciallythemetal
components,e.g.screws.Thisarea
andpartswillgetveryhotonceyour
projectorstartsoperating.
– DONOTplaceanyobjectontop
yourprojector.Theymaynotonlybe
damagedbutalsoleadtoreafter
beingoverheated.
Coolingfansaredesignedforcooling
yourprojector.Fanspeedisauto
adjustedsubjecttointernaltemperature
ofyourprojector.
Airoutlet(Forheatexhaust)
Place your projector correctly
Useyourprojectoratspeciedlocation
incorrectway.Invalidprojectorlocation
mayshortenlife-cycleoflampsoreven
leadtosevereincidentsorre.
Note
Precautions on ceiling mount
installation:
• Getqualiedtechniciantoinstallthe
ceilingmountracket.
• Warrantyofyourprojectordoesnot
coverhazardsanddamagecaused
byusingorincorrectlyinstalled
ceilingmount.
DONOTtiltyourprojector
morethan10degrees.
DONOTtiltyourprojector
morethan10degrees.
DONOTputtheprojector
onaverticalprojection.
DONOTputtheprojector
upsidedowntomakea
projection.
DONOTputtheprojector
oneithersidetoprojectan
image.
Note
Avoid installing your projector as
illustrated below: