37
1
Turn off the projector and unplug the power cord.
2 Wait 60 minutes to allow the projector to cool thoroughly.
3 Remove the lamp door by (a) removing the screw on the side of the lamp door,
(b) lifting the door off.
4 Loosen the captive screw that attaches the lamp housing to the projector.
Carefully remove the lamp housing. Dispose of the lamp in an environmentally
proper manner.
5 Install the new lamp housing and tighten the screw.
6 Re-attach the lamp connector to the projector.
7 Replace the lamp door by sliding it into place.
8 Plug in the power cord and press the Power button to turn the projector back on.
9 To reset the lamp hour timer, navigate to the Status and Service menu and
select Reset Lamp Hours. See page 31 for details.
To Next Page
Loading...
Need help?
General
