InFocus SP-LAMP-088 - User Manual

IN3138HD Lamp Module Replacement Instructions: SP-LAMP-088
1) Loosen the single screw on the lamp compartment cover.
2) Remove the lamp compartment cover.
3) Remove the three screws from the lamp module.
4) Lift the module handle up.
5) Pull firmly on the module handle to remove the lamp
module.
NOTES:
Always use the InFocus lamp module designed for your projector model. Using the wrong lamp module may cause premature lamp failure and possible damage
to the projector.
You can order new lamps from www.infocus.com (in select areas), your retailer or your dealer. Only genuine InFocus lamps are tested for use in this pro-
jector. Use of non InFocus lamps may cause electrical shock and fire, and may void the projector warranty. InFocus is not liable for the performance, safety or
certification of any other lamps.
WARNINGS:
• The projector uses a high-pressure mercury glass lamp. The lamp may fail prematurely, or it may rupture with a popping sound if jolted, scratched, or
handled while hot. The risk of lamp failure or rupture also increases as the lamp age increases; please replace the lamp when you see the “Replace
Lamp” message.
• To avoid burns, allow the projector to cool for at least 60 minutes before you replace the lamp.
• Unplug the power cord before replacing the lamp.
• Do not drop the lamp module. The glass may shatter and cause injury.
• Do not touch the glass surface of the lamp module. Fingerprints can obscure projection sharpness and may cause the glass to shatter.
• Be extremely careful when removing the lamp module. In the unlikely event that the lamp ruptures, small glass fragments may be generated. The lamp
module is designed to contain most of these fragments, but use caution when removing it.
• Before replacing a ruptured lamp, clean the lamp compartment and dispose of cleaning materials. Wash hands after lamp replacement.
• When replacing the lamp while the projector is ceiling-mounted, wear protective eyewear to prevent eye injury.
• Hg-Lamp contains mercury. Manage with accordance with local disposal laws. See www.lamprecycle.org

Summary

Projector Lamp Module Replacement

Important Notes and Safety Warnings

Provides essential notes on using genuine lamps and critical warnings for safe handling and replacement.

Lamp Module Removal Procedure

Step-by-step instructions for safely removing the old lamp module from the projector.

Lamp Module Installation Procedure

Guidance on installing the new lamp module, ensuring correct alignment and connection.

Lamp Timer Reset Procedure

Accessing the OSD Menu for Reset

Instructions on how to navigate the projector's On-Screen Display (OSD) menu.

Resetting the Lamp Hour Timer

Detailed steps to reset the lamp timer via the 'Lamp Hour Reset' function in the OSD.

InFocus SP-LAMP-088 Specifications

General

Model	SP-LAMP-088
Category	Projector Accessories
Type	Projector lamp
Compatibility	InFocus projectors
Lamp Type	UHP
Wattage	190W
Lamp Wattage	190W
Voltage	100-240V