Ingersoll-Rand 99V60P107 User Manual (English)

Other manuals for Ingersoll-Rand 99V60P107

Operation And Maintenance Manual27 pages

Questions and Answers:

L
Lisa HenryAug 11, 2025
Why is my Ingersoll-Rand Tools having low power?
- K
  Kevin FloresAug 11, 2025
  If your Ingersoll-Rand Tools are experiencing low power or low free speed, several factors could be the cause. Begin by checking the air pressure at the inlet, ensuring it does not exceed 90 psig (6.2 bar/620 kPa). A plugged screen can also restrict performance; clean it with a suitable cleaning solution, or replace it if necessary. Remember to always use a grinder with an inlet screen to prevent dirt ingestion. Other potential issues include worn or broken vanes or a worn or broken cylinder, which would require replacement. Finally, improper lubrication or dirt build-up in the motor can lead to reduced power; lubricate the grinder as instructed, and if the problem persists, disassemble the motor for inspection and cleaning.
N
Nicholas LewisAug 18, 2025
What to do if my Ingersoll-Rand Tools has air leaks?
- A
  Andrea DavilaAug 18, 2025
  If you're experiencing air leaks in your Ingersoll-Rand Tools, start by checking the valve seat and valve seat washer for wear and replace them if necessary. Also, inspect the throttle valve seals and replace them if they are worn. A worn cylinder case gasket can also cause leaks, so replace it if needed. Ensure the oiler plug and oiler plug washer are tight; if the leak continues, replace the washer. Lastly, inspect the cylinder case for a distorted face and lightly polish it to remove any high spots, or replace the cylinder case assembly if it's damaged.
M
Morgan AvilaAug 26, 2025
How to fix rough operation in Ingersoll-Rand Tools?
- S
  Suzanne OrtegaAug 26, 2025
  If your Ingersoll-Rand Tools are operating roughly, it could be due to several reasons. Start by examining the rear rotor bearing and front rotor bearing for wear or damage and replace them as needed. If the rear rotor bearing seal assembly is worn or damaged, replace it. Also, check the rotor key for wear and replace it; inspect the arbor and rotor for key slot wear and replace if necessary. A bent arbor can also cause rough operation; mount the arbor on centers and check the bearing diameter runout with an indicator, replacing the arbor if the runout exceeds 0.002” Total Indicator Reading.
Z
zhangkyleSep 2, 2025
What causes scoring in Ingersoll-Rand Tools?
- A
  Amy TuckerSep 2, 2025
  Scoring in Ingersoll-Rand Tools can be caused by improper assembly. Ensure that all motor parts are properly aligned before clamping the motor assembly. Another potential cause is rotor bearing seal misalignment. To correct this, loosen the cylinder case screws, rotate the spindle by hand to align the seal, and then retighten the screws to 14 ft–lb (19 Nm) torque, ensuring the spindle rotates freely.