Ingersoll-Rand QXXD2PT004PQ04 User Manual

TL-VP1T-UIM
Edition 1
October 2021
Save These Instructions
QX Connect Series
User Manual
E

Ingersoll-Rand QXXD2PT004PQ04 Specifications

General

Model	QXXD2PT004PQ04
Brand	Ingersoll Rand
Drive Size	1/4 in
Free Speed	1800 RPM
Air Inlet Size	1/4" NPT

Summary

Intended Use and Operation

How to Program

Methods for programming tools: via ICS software or the back cap tool display.

Tool Features and Indicators

Back Cap Identification

Identifies symbols on the back cap for tool navigation and functions.

Status LEDs

Describes the four status LEDs and their meanings based on color and blinking.

Overview of Menu Screens

Getting Started

Initial Screen and Interface Selection

INSIGHT Connect App Pairing

INSIGHTqcx Controller Pairing

Standalone Basic Mode

Switching Between Basic and Normal Modes

Instructions to switch between basic and normal modes, requiring password entry.

Password Management

Basic Mode Operations

Setting the Target Value

Torque or Angle Mode Selection

Normal Mode Operations

Programmable Sets (PSets)

Overview of PSets, selection process, and accessing PSet editing via password.

Editing PSet Target and Torque High Limit

Editing PSet Angle and Torque Limits

Editing PSet Speed and Batch Count

Drive Mode Selection

Explanation of Ergonomic, Performance, and Productivity drive modes for fastening.

ETS Mode and Fastening Control

Target and Limit Definitions

Secondary Limits and Run Screen

Cycle Count, Faults, and Communications

Detailed Communications Configuration

Mode Switching Reiteration

Tool Fault Codes and Troubleshooting

Motor Controller Faults (A-10 to E-0A)

Troubleshooting guide for initial motor controller fault codes and their solutions.

Motor Controller Faults (E-0B to E-81)

Troubleshooting additional motor controller fault codes and specific error conditions.

Firmware and Lock Faults

Fault codes related to firmware upgrades, tool locking, and system errors.