92 Options and programming methods
Anti-intrusion control panels
- Confirm - if enabled, the system will ask the user for confirmation (press )
before activating the function-key shortcut. This method draws the users
attention to requested operations that do not require codes, and thus avoids
accidental arm/disarm operations, etc.
This option is not available for Alien keypads.
It is possible to program a certain number of outputs which can be activated or
deactivated via keypad without entering a user code. For further details refer to
paragraph 7-28 Activating outputs without authentication.
Via Alien keypad
Access the “Settings” section by tapping the button , type-in a valid user code in
order to access the “Alien” section.
The complete description of the parameters in this section can be found in paragraph
paragraph 2-3 Keypads in the user manual.
Via PC
The process of programming the graphic interface and maps on the Alien keypad must
be done through the SmartLeague software program.
Once you have selected the keypad from the system tree menu on the left, select
“Touch keypad” as type of keypad. The “General” section, which is the same for all
keypad types, appears with the following sections:
• “Alien graphics”, for the graphic interface setup (backgrounds, buttons, icons)
• “Alien maps”, for the configuration of the graphic maps accessed by means of the
key in the “Maps” section of the “APPs” .
In order to change the Alien parameter settings, your computer must be connected to
the USB port of the keypad.
For a complete description of the programming process of the Alien keypad, refer to the
SmartLeague software manual.
7-21
Readers
This section allows you to programme the reader options.
Via Keypad
Type-in Code
(Installer PIN)
, PROGRAMMING Readers .
Enable/disable
This section allows you to add/remove readers to the I-BUS configuration, by means of
keys and .
If it is a reader simulated by the Air2-BS200, a “W” will be shown at the end of the
description.
ChoosePeripheral
This section allows you to program the various options of the selected reader.
• Description - editable field for the name of the digital key user.
• Partitions - use or to enable/disable the reader on the system partitions.
• Shortcuts - this section allows you to programme the shortcuts associated with the
4 differently-coloured LEDs on the reader. In order:
•• Red LED shortcut
•• Blue LED shortcut
•• Green LED shortcut
•• Yellow LED shortcut
The shortcut associated with the LED can be one of the following types:
•• None
•• Arm/Disarm
•• Stop alarms
•• Clear call queue
•• Delete memory
Table 7-16:
Keypads - via SmartLeague software programme
Option Part of the system Template/section
Enable/disable
/ Project
ChoosePeripheral
Keypads - select the keypad Programming
CONTINUE?OK=YES
Enable/disable
READER 001
READER 002
READER 003
PROGRAMMING
Expansions
Keypads
Readers
Readers
Enable/disable
ChoosePeripheral
Prog. Address
To Next Page
Loading...
