THE DIRECT-IT IN (UAA1)
USAGE
For use with most standard airmovers on the market today. This adapter dries
positively only by moving dry air into trapped spaces.
SERIOUS PERSONAL OR EYE INJURY CAN RESULT FROM FAILURE TO FOLLOW
SERIOUS PHYSICAL INJURY CAN RESULT FROM FAILURE TO
FOLLOW THESE INSTRUCTIONS:
1. Wear protective eyewear such as safety glasses when stretching, fastening or releasing
hooks. 2. Do not stretch cord more than 50%. (Example 12” to max 18”). Cords can be
stretched more than 50%, but could cause failure of cord or hook & result in serious eye or
other injury. 3. Inspect cord before use. Do not use if cord is frayed or hooks are bent or
damaged. 4. Cord acts like a rubber band. Do not stretch cord toward or away from you to
avoid being struck by hooks. Pull to one side and keep your face and body away from re-
bound path.
HOW TO ATTACH THE DIRECT-IT IN (UAA1)
Step 1. Place the Direct-It IN in front of the airmover to be used (as
shown in picture below).
Step 2. Insert the snout of the airmover into the back of the Direct-It
IN housing.
Step 3. While holding the Direct-It IN housing, carefully stretch the
lower bungee cord around the base of the airmover and
fasten the cord hook into the lower eyelet on the Direct-It IN.
Page 1 of 4
READ BEFORE OPERATING or ATTACHING THE ADAPTER
To Next Page
Loading...