Inkbird ISV-200W - Settings; Temperature and Timer Settings; Temperature Unit Switch and Calibration

4
3.1 Temperature setting and timer
setting
1. Press the “ ” button to enter main
interface setting mode.
2. When the set temperature icon is flashing,
you can adjust the temperature by pressing
the “ ” button or the “ ” button.
3. Press the “ ” button again to set the
hours of the countdown, another press on
the “ ” button to set the minutes of the
countdown.
Note: Long press on the “ ” button or
the “ ” button will increase or decrease
the temperature value quickly.
3.2 Temperature Unit Switch &
Calibration
3.2.1 Temperature Unit Switch
1. Hold the “ ” button for seconds to enter
the temperature unit setting page.
2. Press the “ ” button or the “ ” button
to switch between ℉ and ℃.
3. Hold the “ ” button to confirm the
selection and back to main interface.
3.2.2 Calibration
1. Hold the “ ” button for seconds to enter
Settings03
3.1 Temperature setting and timer
setting
1. Press the “ ” button to enter main
interface setting mode.
2. When the set temperature icon is flashing,
you can adjust the temperature by pressing
the “ ” button or the “ ” button.
3. Press the “ ” button again to set the
hours of the countdown, another press on
the “ ” button to set the minutes of the
countdown.
Note: Long press on the “ ” button or
the “ ” button will increase or decrease
the temperature value quickly.
3.2 Temperature Unit Switch &
Calibration
3.2.1 Temperature Unit Switch
1. Hold the “ ” button for seconds to enter
the temperature unit setting page.
2. Press the “ ” button or the “ ” button
to switch between ℉ and ℃.
3. Hold the “ ” button to confirm the
selection and back to main interface.
3.2.2 Calibration
1. Hold the “ ” button for seconds to enter