Test Modes
1. 10BaseT Cable test
Step 1
Plug one end of the tested cable into the transmitting RJ45 jack on
the master unit marked with a
n arrow
and the other end of the cable into
the remaining receiving RJ45 jack
Step 2
Slide power switch on. The upper row of LEDs will start to scan in
sequence
if the Auto/Manual
button is
set on
"Auto" mode. The
LED for pin
1 will light up if the button is in "Manual" mode.
S
tep
3
Switch
back and forth from Auto or Manual
scanning
mode
by
pressing
the
Auto/Manual
button
on
the
side
of
the
master testing
unit.
S
tep
4
Once both ends of the cable are plugged in properly,
the second row of
LEDs
will
illuminate
according
to
the
corresponding
LEDs in the top row.
S
tep
5
Read
the
results
of
the
LED
display
for
the
pin
configuration status
of the tested cable. If you fail to read
the results the first time
in Auto
mode,
you
ma
y
wait
for
the
second
LED
scan,
or simply
switch to
Manual
mode
for
pin
by
pin
testing. In
Manual mode,
pressing
the
square
"Test"
button
will
advance
testing
to the
next pin.
2. 10Base
-
2
cable
test
Step
1
Plug the two attached BNC adapter cables on both RJ45 jacks.
Then connect the tested cable to each end
of the BNC adapter
cables
.
Step
2
Please follow directions for the UTP/STP Cable Test and use the operations manual for the correct LED pin
out display
To Next Page
Loading...