Step
3
As Coaxial cable has only two wires, we suggest you read
the result of the LED scan using Manual mode.
3. Remote Test
Step
1
Plug one end of the tested cable to the transmitting RJ45 jack on the
master unit marked with a
n arrow
and plug the other end into the remote
terminator. If the tested cable is installed in a patch panel or wall
plate, you may use the included patch cable to solve the connector
gender problem. Now, set the
Auto/Manual switch to Auto mode for one
-
person
tes
ting.
Read the test results from the LED display on
remote terminator
4. Loop
-
Back
-
Test
Test a cable without remote unit
:
(This test
is usually
only
possible
for non
-
installed cables.)
1.
First
Plug one
end into
the slot of the
main
unit
is labeled
TX
(
=
transmitting)
and the other end
into the slot
with
the
RX (
=
receiving)
labeled.
2.
Second
If
at the same time
on the bottom line
of the
display
, the LEDs
light up
the top,
then
the
individual
wires of the cable
are wired
correctly
.
Test
results
Continuit
y
Pin 2
is continued
To Next Page
Loading...