The safety and integrity designed into the InMotion® E3000 Compact Strider can only be maintained
when the InMotion® E3000 Compact Strider is regularly examined for damage and wear. Special
attention should be given to the following:
STORAGE
MAINTENANCE
11
1. To store the InMotion® E3000 Compact Strider, simply keep it in a clean dry place.
2. The InMotion® E3000 Compact Strider is approximately 24.3 inches long x 17.5 inches wide x 11.4
inches tall. These dimensions will vary. Please measure your InMotion® E3000 Compact Strider if
exact dimensions are needed.
3. Grasp the handle located on the top of the product to move the InMotion® E3000 Compact Strider.
Do not use the Pedal Arms to move the InMotion® E3000 Compact Strider.
NOTE: A standard crank extractor tool is required to remove the CRANKS(72) from the AXLE(73).
1. Adjust the TENSION KNOB(21) and verify that it functions properly and the resistance changes.
2. Inspect the RESISTANCE TUBES(69) for nicks and cuts. Replace damaged RESISTANCE
TUBES(69).
3. Verify that the WARNING LABEL(55) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement WARNING LABEL(55) if it is missing or damaged.
4. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
5. Worn or damaged components shall be replaced immediately or the InMotion® E3000 Compact
Strider removed from service until repair is made.
6. Only Stamina Products supplied components shall be used to maintain/repair the InMotion® E3000
Compact Strider.
7. Keep your InMotion® E3000 Compact Strider clean by wiping it off with an absorbent cloth after
use.
OPERATIONAL INSTRUCTIONS
FORWARD AND REVERSE
The InMotion® E3000 Compact Strider can be used in forward and reverse directions to vary the muscles
that you work. This will help you to stay motivated and achieve the best results. To change directions, simply
slow the pedals down until they stop, then pedal in the opposite direction.
The load level of InMotion® E3000 Compact Strider can be changed
at any time during your workout. Adjusting your load level will allow you
to increase or decrease your intensity level.
To increase the load, turn the TENSION KNOB(21) clockwise. To
decrease the load, turn the TENSION KNOB(21) counterclockwise.
LOAD LEVEL ADJUSTMENT
To Next Page
Loading...
Need help?
General
