EasyManua.ls Logo

InMotion V12Pro - Riding Instructions

InMotion V12Pro
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
RIDING INSTRUCTIONS
1. When riding this product, please comply with local laws and regulations and policy requirements. It is prohibited to use it in
areas where entry is prohibited by local laws and regulations or related management units.
2. When riding, please respect the right of way of pedestrians. Pass on the left side of pedestrians as much as possible.
When facing pedestrians, keep to the right and slow down. Avoid alarming pedestrians, especially the elderly, children,
disabled people, and pregnant women. When approaching pedestrians from behind, remind them and slow down when
passing.
3. Do not drive when fatigued. When riding, make sure you and others are visible. Please pay attention to maintaining a
sufficient safe distance from pedestrians or other vehicles to avoid the risk of collision. Therefore, when you approach
or pass through crowded pedestrian areas, intersections, or turning points, please slow down, yield to pedestrians and
other vehicles.
4. Please do not suddenly accelerate or decelerate. Whenriding, always stand on the pedals with both feet. Stunts are
prohibited. Do not drive at speeds exceeding the vehicle's limit, otherwise, there may be a risk of losing control, collisions,
and falls.
5. Please do not turn while riding at high speed or suddenly brake. The above actions can easily cause danger (such as
slipping and falling). Be sure to slow down when turning. High-speed turns can lead to loss of control, which may cause
the vehicle to overturn and there is a risk of injury or death.
6. Do not use headphones, earplugs, mobile phones, handheld shooting equipment, or engage in any activity or behavior that
may distract your attention while riding a bicycle so that you can better monitor the external environment.
7. Please do not ride under the following conditions, including but not limited to: severe weather, low visibility, night, darkness.
Each of the above conditions will increase the risk of accidents.
8. For any reason, please do not ride a bicycle in snowy, rainy, slippery roads, muddy roads, or icy conditions. The resistance
of tires on wet or slippery roads decreases and the braking distance increases, making it easier to slip or lose control.
When riding in rainy or snowy weather, the vehicle may become waterlogged, leading to functional damage, fires, or even
explosions due to damp batteries. Damage and losses caused by water ingress are not covered by the warranty.
9. When riding, please avoid obstacles, potentially dangerous road surfaces, and difficult-to-cycle road surfaces (including
but not limited to wet and slippery surfaces, ice surfaces, swimming pools and other water areas, loose sand or dispersed
material surfaces, steps and nearby areas, and uneven surfaces).
10. When you approach pedestrians or cyclists, notify them of your presence when you are not seen or heard.
11. When approaching or crossing intersections, street corners, or any type of gate, be sure to slow down.
12. Do not ride at unsafe speeds. You must make the correct judgment based on your driving skills and surrounding
environment.

Related product manuals