Inner Range inception - User Manual

Quick Start Guide
Connect and plug in the power cord
Begin commissioning
• You have successfully connected
to your Inception Controller
• To commission the system, it is
recommended that you use the
Commissioning Checklist, which will
guide you through the entire
process from start to nish
Quick Start Guide
1
Wait for the Inception Controller to start up
• Initially, the POWER LED will turn on indicating power is being supplied
to the controller
• During startup, the LEDs will light up in order from left to right to show progress
• The controller is ready when the SYSTEM LED is ashing
2
5
Log into the web interface
• Once connected, you will be
presented with a login screen
• The default Installer
credentials are:
Username: installer
Password: installer
PIN: 01
4
Inception, SkyTunnel and SIFER are registered trademarks of Inner Range Pty Ltd.
Product specifications subject to change without notice. Pictures shown may vary from actual product.
© 2016 Inner Range Pty Ltd all rights reserved.
Part Number: 636300QS February 2016
D
E
S
I
G
N
E
D
I
N
A
U
S
T
R
A
L
I
A
240V AC
Simple & Easy Installation
Integrated Security - Access Control
For more information, visit www.innerrange.com/inception.
There you will nd installation guides and videos to help you
get the most out of your Inception System.

Inner Range inception Specifications

General

Model	Inception
Category	Controller
Users	10, 000
Event Log	50, 000 events
Power Supply	12-24V DC
Max. Readers/Doors	32
Max. Users	10, 000
Max. Areas	64
Onboard Inputs	8
Network	Ethernet
Onboard Outputs	4
Communication	Ethernet, RS-485
Operating Temperature	0°C to +50°C (32°F to 122°F)

Summary

Inception Controller Setup and Power On

Connecting the Power Cord and Initial Power Up

Connect the power cord and observe the POWER LED status and startup sequence.

Understanding Controller Startup LEDs

Monitor the progress of LEDs during the controller's startup sequence.

Connecting to the Inception Web Interface

WiFi Access Point Connection Method

Connect to the Inception's Wi-Fi network using its serial number and default password.

Remote Access via SkyTunnel

Access the controller remotely through SkyTunnel using its serial number.

Wired Ethernet Connection Options

Direct and Local Network Ethernet Setup

Connect the controller to a computer or local network using an Ethernet cable.

Locating the Controllers IP Address

Learn methods to find the IP address via LCD Terminal or Connect Utility.

Web Interface Access and System Commissioning

Logging into the Inception Web Interface

Use default installer credentials to log in to the web interface.

Initiating System Commissioning Process

Follow the Commissioning Checklist for comprehensive system setup.