Innokin iTaste VTR - Page 7

adjustment of voltage or waage seng. While the device is on, if you press the funcon key buon the
display screen will show resistance ( Rx.x , for example R2.2 ). Release the funcon key aer 1 second to
display output of the last adjustment of voltage or waage ( U x.x , for example : U4.5 or P x.x , P8.0 ).
While the iTaste VTR is cycling through is displayed sengs you can press funcon key buon to switch
to or from Variable Voltage mod or Variable Waage mod. Use the Rotaonal wheel to adjust your
waage/voltage; clockwise (+) and counterclockwise(-)
Rotaonal wheel: Rotaonal wheel for adjustments to the output. The wheel can be rotated clockwise
(+) and counterclockwise(-) to adjust the Voltage and Waage. Variable Voltage can be adjusted from
3.0 – 6.0 volts in .1 volt increments. Variable Waage can be adjusted from 3.0 – 15.0 W in .5 was
increments.
Variable Voltage Mode
When you press the funcon key, the screen will show you the Ohms first followed by the last
adjustment (The last adjustment may be a voltage or waage seng), aer showing the last adjustment,
the iTaste VTR will enter variable voltage mode by pressing “funcon key” for 1 second. Voltage can be
adjusted from 3.0 to 6.0 volts in .1 volt increments by moving the rotaonal wheel clockwise (+) and
counterclockwise(-) .
1/EN-8
Variable Waage Mode :
When you press the funcon key, the screen will show Ohms first followed by the last adjustment (The
last adjustment may be a voltage or waage seng), aer showing the last adjustment, the iTaste VTR
will enter variable waage mode by pressing “funcon key“ for 1 second. Waage can be adjusted from
3.0 to 15 was in .5 wa increments by moving the rotaonal wheel clockwise (+) and counterclock-
wise(-).
Load Ohms Meter :
Press the “Funcon” buon for 2 seconds, the digit screen will display load Ohms if there is any connect-
ed load on this product, the load Ohms range will range from 1.0ohm-9.9ohm. The digit screen will
display "NON" if no load has been detected.
Built-in 3 digit LED display: (Baery Capacity ,Ohms meter, Volts /Was, Atomizer voltage output).
9/EN-9 10/EN-10
LED Light Blinking Mode:
The LED light will blink different colors to indicate the current baery voltage.